Wagan Tech Pure Line 3000W Pure Sine Inverter (ETL) | 12V
Early Black Friday Price Drop Guarantee
- Buy now, and if our price drops by Black Friday, we'll refund the difference.
- Found it lower elsewhere? We'll beat it.
Early Black Friday Price Drop Guarantee

The Wagan Pure Line 3000W Pure Sine Inverter converts 12 volt DC into 115 volt, 60 Hz pure sine wave AC. It runs 3,000 watts continuously and surges to 6,000 watts for motor starts. Three grounded outlets, a 2.1A USB port and high output terminals give you both plug-in and hard-wired options.
It suits RVs, work sites, camping, boating and off-grid systems that run tools and household appliances from a battery bank. It's ETL certified to UL 458 and CSA C22.2 No. 107.1 standards, RoHS compliant and CE approved.
The inverter delivers a true AC sine wave like commercial power, with total harmonic distortion under 3%. Wagan designed it so audio and video systems, computers and communications equipment operate properly, and so motor-driven appliances run cooler, quieter and more efficiently.
TrueRated means Wagan tests the inverter at its full 3,000 watt load and it sustains that load continuously for 24 hours. The 6,000 watt momentary surge covers startup demand. Many appliances draw about twice their running load when they start and some draw up to eight times, so check the startup figure before you connect.
Three grounded NEMA 5-15 outlets supply up to 15 amps at 115V AC. For a 115V device that needs more than 15 amps, or to feed distributed wiring, three insulated high output terminals (neutral, ground and live) sit under a screw-down cover and must be wired to National Electric Code gauge recommendations. A 5V, 2.1A USB port charges phones and tablets.
The outlets are ground fault protected, and a yellow LED lights when the ground fault circuit trips. A ground fault is unintended AC current flowing to ground, which can come from faulty wiring, bad insulation, very long wiring or sparking appliances. To reset, switch the inverter off and back on. If it trips again right away, disconnect appliances or wiring one at a time until it stays on.
A green LED shows normal operation, and a red LED lights when the inverter shuts down for overheating, overload, low voltage or high voltage. A buzzer warns of a low battery at 10.5V, and the inverter shuts down at 10.0V or above 16.5V. Twin high-speed, temperature controlled cooling fans manage heat.
A conformal coating protects the circuits from dust and moisture. Removable covers over the solid mount DC terminals reduce the risk of an accidental short, and the enclosure vents are kept small to limit pest intrusion. A separate ground terminal bonds the case to a chassis or boat grounding system and helps reduce noise around radio frequency devices, while neutral is bonded to ground inside, like utility power.
Set the On, Off, Remote switch to Remote and plug Wagan's optional Pure Line Inverter Remote (item 5603, sold separately) into the front-panel connection to control the inverter from another spot.
Work sites. Run corded tools such as a circular saw or drill from a truck-mounted battery bank.
RVs and campers. Power kitchen appliances and electronics from the house batteries.
Boats. Bond the case to the boat's grounding system and run onboard AC equipment.
Off-grid systems. Supply hard-wired outlets through the high output terminals, installed to code.
A modified sine inverter does not reproduce the true sine wave of utility power. The Pure Line does, and Wagan built it for sensitive electronics such as audio and video equipment, computers and communications gear, plus motorized appliances. If your load includes any of those, a pure sine inverter is the type to choose.
The outlets take plug-in loads up to 15 amps. The high output terminals serve one 115V device that needs more current, or hard-wired outlets elsewhere. In both cases the total AC load stays within 3,000 watts continuous.
Divide AC watts by 10 to estimate DC amps at 12 volts, then size the battery bank and cabling for that current. Wagan specifies deep-cycle, sealed lead acid batteries indoors or inside a vehicle or vessel. Install a 300 amp ANL fuse in the positive cable within 1 foot of the battery. The supplied 3 foot cables cover round trips up to 5 feet in a vehicle with the engine running. For longer round trips, Wagan lists 0 AWG at 6 feet, 00 AWG at 8 feet, 000 AWG at 10 feet, 0000 AWG at 12 feet and 00 AWG x 2 at 14 to 16 feet. Reversed polarity damages the inverter and voids the warranty, so check red to positive and black to negative.
Pick a dry, secure spot away from heat and combustibles, with free airflow front and rear, and mount it horizontally on a wall. Connect insulated 10 gauge copper wire from the ground terminal to the vehicle chassis, the boat's grounding system or the battery's negative terminal, never to the inverter's own negative terminal. Operating temperature is -4°F to 104°F (-20°C to 40°C).
Wagan specifies a 300 amp ANL fuse and fuse holder in the positive battery cable, no more than 1 foot from the battery's positive terminal.
A continuous buzz means input voltage is below 10.5 volts. Recharge or replace the battery, tighten loose connections, and use heavier, shorter DC cables if voltage drop is the cause.
Yes, for temporary use. Keep it 100 feet or shorter and use a safety-approved cord of 14 AWG or heavier.
Wagan warrants it to the original purchaser for two years from the purchase date against defects in material and workmanship.
The Wagan Pure Line 3000W Pure Sine Inverter gives your 12V system 3,000 watts of TrueRated pure sine power, three outlets, USB charging and hard-wire terminals, with ground fault protection and remote control capability. If you'd like help planning the battery bank, fuse or cable runs, the Outbound Power team is happy to help.
Wagan Tech Pure Line 3000W Pure Sine Inverter (ETL) 12V Specifications |
|
|---|---|
| Model | 3810 |
| Output | |
| Continuous Power (TrueRated) | 3,000W, 24-hour continuous |
| Surge Power | 6,000W |
| Output Waveform | Pure sine wave |
| AC Output Voltage | 115V AC |
| Frequency | 60Hz ± 0.5 |
| Total Harmonic Distortion | Less than 3% |
| Efficiency | Up to 90% |
| No Load Current Draw | Less than 2.5A |
| DC Input | |
| Input Voltage | 12V DC |
| Operating Input Range | 11V to 15V DC |
| Low Battery Alarm | 10.5V ± 0.5V DC |
| Low Battery Shutdown | 10.0V ± 0.5V DC |
| Over Voltage Shutdown | 16.5V ± 0.5V DC |
| DC Terminals | Solid mount positive and negative, removable safety covers |
| Included DC Cables | 36 in. (3 ft), 2x 4 AWG, ring connectors |
| Outlets and Ports | |
| AC Outlets | 3 grounded NEMA 5-15, ground fault protected |
| AC Outlet Current | Up to 15A at 115V AC |
| High Output AC Terminals | 3 insulated (neutral, ground, live), for loads over 15A |
| USB Power Port | 5V, 2.1A |
| Power Switch | On, Off, Remote |
| Remote Switch Connection | Yes, wired remote item 5603 sold separately |
| Indicators | Power LED (green), ground fault LED (yellow), fault LED (red) |
| Protection | |
| Overload | Automatic shutdown |
| Overheating | Cooling fans with automatic shutdown |
| Short Circuit | Internal fuses |
| Ground Fault | Ground fault protected outlets |
| Low Battery | Audible alarm and automatic shutdown |
| Neutral to Ground Bond | Yes |
| Grounding | Separate ground terminal (true ground) |
| Cooling | Twin high-speed fans, load and temperature controlled |
| Circuit Board | Conformal coating against dust and moisture |
| Installation | |
| Recommended Battery Fuse | 300A ANL |
| Fuse Location | Within 1 ft of battery positive terminal |
| Supplied Cables | Round trip up to 5 ft, vehicle engine running |
| Cable Gauge, 6 ft Round Trip | 0 AWG |
| Cable Gauge, 8 ft Round Trip | 00 AWG |
| Cable Gauge, 10 ft Round Trip | 000 AWG |
| Cable Gauge, 12 ft Round Trip | 0000 AWG |
| Cable Gauge, 14 to 16 ft Round Trip | 00 AWG x 2 |
| Battery Type | Deep-cycle sealed lead acid |
| Battery Current Estimate | AC load in watts divided by 10 = DC amps at 12V |
| Ground Wire | Insulated 10 gauge copper |
| Wall Mounting | Horizontal |
| Extension Cord | 100 ft max, 14 AWG or heavier |
| Physical | |
| Dimensions | 19.0 x 8.7 x 3.8 in |
| Net Weight | 12.5 lb |
| Operating Temperature | -4°F to 104°F (-20°C to 40°C) |
| Certifications and Warranty | |
| Certifications | ETL certified to UL 458 and CSA C22.2 No. 107.1, RoHS compliant, CE approved |
| Warranty | 2 years, original purchaser |
⚠ WARNING: This product can expose you to chemicals including LEAD, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Yes! Outbound Power is an Authorized Dealer for every single brand and product on our store.
Shipping times vary depending on your location and the product or products ordered.
Order Processing Time
Most products are processed within 1-3 business days. If there is a delay in processing your order, we will alert you with as much information as possible about what to expect.
After order processing is complete, you will receive tracking information to monitor your order while it is in transit.
Order Shipping Time
Following processing, it may take between 3 and 8 days to arrive, depending on your location.
Please refer to the product page for your item and reference the estimated delivery time frame for more details.
Additionally, you can see the estimated delivery time frame during checkout and receive a tracking number once your order ships.
Everything on our store ships for free. Really!
Most items may be returned within 30 days of delivery. Please refer to our Returns & Exchanges policy to determine what items are eligible. Returns are not accepted beyond 30 days following delivery.
Everything sold on our website is brand-new.
No — we price BEAT! Please refer to our Price Beat Promise for full details.
Click to apply at checkout
placeholder