The BougeRV 2000W 12V Pure Sine Wave Inverter with Bluetooth Gives Your RV or Off-Grid System 2000W of Clean 120V Power and Ships With Battery Cables
The BougeRV 2000W 12V Pure Sine Wave Inverter with Bluetooth (model SI122000) changes 12V DC battery power into 2000W of continuous 120V AC, with a 4000W one-second peak for appliances that pull extra power at startup. Its low-distortion pure sine wave output, under 5% THD, is made for sensitive electronics, appliances and everyday devices.
BougeRV designed it for RV travel, camping, overlanding, marine use, outdoor work and off-grid living. It measures 14.96 x 7.4 x 3.94 in, weighs 8.4 lb and comes with battery cables, a wired remote panel and Bluetooth app monitoring. It works only with 12V battery systems.
BougeRV 2000W 12V Pure Sine Wave Inverter with Bluetooth Features
2000W Steady Output, 4000W Surge
The inverter holds 2000W continuously and absorbs a 4000W surge for one second. Overload protection trips at 2300W. Maximum efficiency is above 90%, full-load efficiency is above 85%, and no-load draw is 0.6A or less.
Two AC Outlets, a Hardwire Port and USB
The front panel has one 15A AC outlet, one 20A AC outlet and an AC high power link port for hardwired 120V loads. An 18W USB port supplies 5V/3.4A, 9V/2A or 12V/1.5A. BougeRV recommends loading each AC terminal to no more than 80% of its rated current and keeping the total within the inverter's rated output.
Ground Fault and Five Other Protections
Six protections watch the system: input over-voltage, battery over-discharge, output overload, short circuit, over-temperature and ground fault (GFCI), which trips on leakage above 30mA. A low-voltage alarm sounds at 10.5V, and the over-discharge cutoff is set to 10V and adjustable from 10V to 12V in the app.
Phone and Remote Monitoring
Over Bluetooth, the BougeRV app shows operating data and fault status and lets you change settings such as the 50Hz or 60Hz output and the over-discharge voltage. Stay within 16 ft (5 m), and use Android 8.0 or iOS 13.0 or later. The included remote panel runs on a 19.6 ft (600 cm) cable and displays input and output voltage, output power, frequency, error codes and working status.
Fan Cooling That Starts on Demand
The cooling fan turns on above 113°F (45°C) or when the load passes 40%. If the inverter reaches 167°F (75°C), over-temperature protection shuts it down until it cools. Noise is rated at 60dB or less.
Real-World Applications
RV camping. Run a portable refrigerator, coffee maker and phone chargers from your 12V house battery.
Overlanding and vans. Mount it on a wall or flat and check its status from your phone.
Marine and coastal use. BougeRV lists marine applications and operation near the coast among its uses.
Remote work. Keep laptops, monitors and mobile equipment running away from grid power.
Practical Comparison
2000W Inverter Versus a Larger Inverter
A larger inverter can run bigger combined loads. The 2000W model covers loads up to 2000W running, includes its own 2AWG battery cables and draws 0.6A or less at no load.
Pure Sine Wave Versus a Modified Sine Wave Inverter
A modified sine wave inverter puts out a stepped waveform. This inverter puts out a pure sine wave with under 5% THD, which BougeRV says is suitable for sensitive electronics.
Buyer Guidance
Matching Loads and Battery Current
Pick appliances whose running power is below 2000W and whose startup surge stays under 4000W. A 2500W appliance won't run on this inverter. Check your battery too. BougeRV's manual gives an example: a 1500W appliance needs about 117A from a 12V battery (1500W divided by 12.8V), so a 100Ah battery limited to 100A will trip its own protection. Connecting batteries in parallel to raise available current solves this.
Safe Installation
Install an external DC fuse and/or circuit breaker on the battery cables, sized at 2 to 2.5 times the inverter's rated input current and within 150 mm of the battery. The input has no reverse polarity protection, so confirm positive and negative before connecting. Ground the case, turn the switch OFF before wiring, and connect the AC ground before L and N, following NEC gauge requirements. Leave at least 6 in of clearance and 7.9 in between the air outlet and intake, in a cool, dry, ventilated spot. Don't use it where gas or dust could explode, and disconnect all AC and DC before maintenance.
This May Be A Good Fit If
- Your loads stay under 2000W running
- You have a 12V battery bank in an RV, van or boat
- You want battery cables and a remote panel in the box
- You'd like to check power use from your phone
Common Questions
Will It Work on 24V?
No. It is designed for 12V battery systems only.
Does It Charge Batteries?
No. It converts DC to AC only.
How Do I See How Much Power It's Using?
Open the BougeRV app over Bluetooth, or read output power on the wired remote panel.
What Warranty Does It Have?
BougeRV provides an 18-month warranty.
What's Included
- 1 x 2000W 12V Pure Sine Wave Inverter
- 2 x Battery-Inverter Cable (3 ft, 2AWG)
- 1 x Ground Cable (3.2 ft)
- 1 x Remote Control (19.6 ft Cable)
- 1 x Wrench
- 1 x Replacement Fuses
- 1 x Product Manual
Clean Power for Mid-Size 12V Systems
The BougeRV 2000W 12V Pure Sine Wave Inverter with Bluetooth delivers 2000W of continuous pure sine wave power with a 4000W surge, GFCI and five other protections, and app plus remote monitoring in an 8.4 lb unit. If you'd like help matching it to your battery bank and loads, the Outbound Power team is happy to help.
BougeRV 2000W 12V Pure Sine Wave Inverter with Bluetooth Specifications
|
| Output |
| Model |
SI122000 (12V 2000W) |
| Rated Output Power |
2000W |
| Peak Power |
4000W (1 second) |
| Output Voltage |
120VAC |
| Output Frequency |
50/60Hz (set in app) |
| Output Waveform |
Pure sine wave |
| Total Harmonic Distortion |
<5% |
| Maximum Efficiency |
>90% |
| Full Load Efficiency |
>85% |
| AC Outlets |
1 x 15A, 1 x 20A |
| Hardwire Output |
AC high power link port, 120V |
| USB Port |
1 x 18W (5V/3.4A, 9V/2A, 12V/1.5A) |
| Input |
| Rated Input Voltage |
12VDC |
| Input Voltage Range |
10.5-15.5VDC |
| No-Load Loss |
≤0.6A |
| Battery Cables |
2 x 3 ft (92 cm), 2AWG (32 mm²), included |
| Protection |
| Protections |
Input over-voltage, over-discharge, output overload, short circuit, over-temperature, ground fault (GFCI) |
| Battery Low Voltage Alarm |
10.5VDC (±0.3V) |
| Over-Discharge Voltage |
10VDC (±0.3V), adjustable 10-12V in app |
| Input Overvoltage |
15.5VDC (±0.3V) |
| Overload Power |
2300W |
| Over-Temperature Protection |
≥167°F (75°C) |
| Over-Temperature Recovery |
≤131°F (55°C) |
| Ground Fault Trip |
Leakage >30mA |
| Fan Start |
≥113°F (45°C) or ≥40% load |
| Monitoring |
| Bluetooth App |
BougeRV app, within 16 ft (5 m); Android 8.0+ / iOS 13.0+ |
| Remote Control |
Wired panel on RS485, 19.6 ft (600 cm) cable |
| Remote Display |
Input voltage, output voltage, output power, frequency, error code, working status |
| Indicators |
Fault and running indicators, error codes E1-E6 with beeps |
| Size and Weight |
| Product Size |
14.96 x 7.4 x 3.94 in (380 x 188 x 100 mm) |
| Weight |
8.4 lb (3.8 kg) |
| Mounting |
Wall or horizontal |
| Noise |
≤60dB |
| Operating Temperature |
14°F to 104°F (-10°C to 40°C) |
| Warranty |
| Warranty |
18 Months |
BougeRV 2000W 12V Pure Sine Wave Inverter with Bluetooth Manual
