The Lion Energy Mil-Spec EMP Bag Stores a Generator or Electronics Up to 13 x 17.5 x 14.5 Inches in a Sealed, Shielded Bag
The Lion Energy Mil-Spec EMP Bag is a roll-top shielding bag that Lion says protects generators and electronics from EMP (electromagnetic pulse), HEMP (high-altitude electromagnetic pulse), solar flares and other transient electromagnetic interference. Lion builds it with a durable nylon shell, a copper mesh interior and a nylon sleeve, and describes it as working like a Faraday cage that redirects surges away from what's inside.
Lion makes this bag for larger generators and devices. Its interior measures 15 x 19.5 x 26 inches, it holds a device up to 13 x 17.5 x 14.5 inches, and the bag weighs 5.5 pounds.
Lion Energy Mil-Spec EMP Bag Features
Tested to a Military Standard
Lion lists the bag as tested and certified to MIL-STD-461G RS-105. The label on the bag states that electronics sealed inside correctly are protected from induced voltages up to 50kV/m.
Nylon Shell With a Copper Mesh Interior
The bag pairs a durable nylon outer shell with a copper mesh interior and a nylon sleeve. Carry handles on the outside let you lift and move it.
Room for Larger Devices
The exterior measures 16 x 20.5 x 26.75 inches (406.4 x 520.7 x 679.45 mm), and the interior measures 15 x 19.5 x 26 inches (381 x 495.3 x 660.4 mm). The largest device it takes is 13 x 17.5 x 14.5 inches (330.2 x 444.5 x 368.3 mm).
Roll-Down Seal With Webbing Ties
You seal the bag by pressing the top tightly together and rolling it down toward the front or back. Webbing ties then thread through D-rings on both sides and cinch the roll snug.
Real-World Applications
Emergency preparedness. Store a power station sealed in the bag as part of your emergency plan, ready to take out when you need it.
Backup electronics. Keep spare electronics you'd want after an emergency shielded and stored together.
Practical Comparison
Mil-Spec EMP Bag Versus a Standard Storage Bag
An ordinary storage bag keeps dust off and cushions bumps. The Mil-Spec EMP Bag adds a copper mesh interior and a roll-down seal built for shielding, and Lion lists it as tested and certified to MIL-STD-461G RS-105.
Buyer Guidance
Measure Before You Buy
Check that your power station or device fits within Lion's maximum device size of 13 x 17.5 x 14.5 inches, not just the interior size.
Follow the Sealing Steps
Turn the power unit off and set it all the way into the bottom of the bag. Press the top tightly together and roll it downward toward the front or back. A correct seal is uniform and snug all the way across. Then thread the webbing ties through the D-rings on both sides and cinch them down. Lion says following these directions is critical to how the bag works, and misuse can permanently damage the shielding material.
This May Be A Good Fit If
- You want to store a generator or power station sealed against EMP and HEMP
- Your device fits within 13 x 17.5 x 14.5 inches
- You keep backup electronics in long-term storage
- You can store the bag somewhere dry
Common Questions
Can I Charge My Power Station Inside the Bag?
No. Lion says not to charge or otherwise use your power unit while it's inside the bag.
Can the Bag Get Wet?
Keep it dry. Lion warns that moisture can damage the bag, so avoid exposing it to moisture or water.
Can I Store Electronics Without a Power Station?
Yes. Lion says the bag works with or without a power unit. Its instructions place loose devices in a Lion Energy storage box inside the bag. That box isn't listed as included with this bag, so ask our team before you plan on it.
What Size Device Fits Inside?
Up to 13 x 17.5 x 14.5 inches (330.2 x 444.5 x 368.3 mm).
What's Included
Shielded Storage for Your Backup Power
The Lion Energy Mil-Spec EMP Bag gives a larger generator or set of electronics a sealed nylon and copper mesh bag that Lion lists as tested to MIL-STD-461G RS-105. If you'd like help checking whether your power station fits, the Outbound Power team is happy to help.
Lion Energy Mil-Spec EMP Bag For Larger Generators and Devices Specifications
|
| Model |
Mil-Spec EMP Bag (SKU 50170164) |
| Protection |
| Lion-Stated Protection |
EMP, HEMP, solar flares and transient EMI |
| Test Standard |
MIL-STD-461G RS-105 |
| Label Rating |
Induced voltages up to 50kV/m when sealed correctly |
| Construction |
Nylon shell, copper mesh interior, nylon sleeve |
| Size |
| Exterior Size |
16 x 20.5 x 26.75 in (406.4 x 520.7 x 679.45 mm) |
| Interior Size |
15 x 19.5 x 26 in (381 x 495.3 x 660.4 mm) |
| Max Device Size |
13 x 17.5 x 14.5 in (330.2 x 444.5 x 368.3 mm) |
| Physical |
| Weight |
5.5 lbs |
| Closure |
Roll-down top, webbing ties through D-rings on both sides |
| Handles |
Carry handles |
| Package Dimensions |
2 x 9 x 12 in |
| Use Limits |
| Moisture |
Keep away from moisture and water |
| Power Unit Inside |
Turn off; do not charge or use while inside |
Lion Energy Mil-Spec EMP Bag For Larger Generators and Devices Manual