The Victron Orion-Tr Smart 12/48-8A Isolated DC-DC Charger Steps a 12 V Source Up to Charge a 48 V Battery Bank
The Victron Orion-Tr Smart 12/48-8A is an isolated DC-DC charger that takes 8 to 17 V in and delivers a regulated 48.2 V out. It can charge a 48 V battery from a 12 V alternator or a 12 V battery, or serve as a fixed-voltage 48 V power supply. The input and output are galvanically isolated, with 200 V DC isolation between input, output and case.
It is configured and monitored over Bluetooth with the VictronConnect app. Think of it as a purpose-built bridge between a 12 V vehicle or boat electrical system and a 48 V lithium or lead-acid bank, with charge stages, engine-running detection and remote on/off. Output is modest at 8 A, so it suits topping up and trickle-feeding rather than rapid charging.
Victron Orion-Tr Smart 12/48-8A Isolated DC-DC Charger Features
12 V Input To 48 V Output
Input voltage range is 8 to 17 V. Nominal output is 48.2 V, adjustable from 40 to 60 V in the app. Continuous output current is 8 A at 40 degrees C (104 degrees F), with up to 15 A for 10 seconds, and a short circuit output current of 25 A.
Galvanic Isolation Between Input And Output
Victron lists 200 V DC isolation between input, output and case. That keeps the 12 V starter circuit separate from the 48 V bank, and the two sides do not need to share a negative.
Three-Stage Adaptive Charging
In charger mode the Orion follows bulk, absorption and float stages, with eight preprogrammed battery settings and a fully programmable algorithm. For lithium batteries the absorption time is fixed, with a default of 2 hours, and you can change that in VictronConnect.
Smart Alternator And Engine-Running Detection
Built-in detection watches the input voltage to see whether the engine is running, so the charger does not drain the starter battery when the alternator stops. It works with conventional and smart alternators. You can disable it or use an external engine-running signal.
Power Supply Mode
Switch the unit to a fixed output voltage and it works as a DC-DC power supply. In this mode the input voltage lock-out decides when the output is on.
Remote On/Off And Bluetooth
A two-pole screw terminal accepts a switch, a switched positive or negative signal, or a BMS charge-control contact. The unit ships with a wire loop fitted, so it is always on until you remove it. Setup, monitoring and firmware updates run through the VictronConnect app.
Built-In Protection
Victron lists short-circuit proof operation, overload protection, over-temperature protection and connector over-temperature protection. Output power derates by 3 percent per degree C above 40 degrees C. The unit is not protected against reverse polarity.
Real-World Applications
-
48 V lithium banks charged from a 12 V vehicle. Add charging from a 12 V alternator to a 48 V house battery.
-
Boats with 12 V engine systems and 48 V house power. Use engine charging without joining the two electrical systems.
-
Utility vehicles and work trucks. Keep a 48 V auxiliary bank topped up from the 12 V chassis.
-
Off-grid and backup systems. Maintain a 48 V bank from a 12 V battery source in a small setup.
-
Fixed 48 V supply from 12 V. Power 48 V equipment from a 12 V battery using power supply mode.
How The 12/48-8A Compares To Other Orion-Tr Smart Isolated Models
Victron's isolated Orion-Tr Smart range covers 12 V, 24 V and 48 V inputs and outputs. The model name gives input voltage, output voltage and output current, so this one is 12 V in, 48 V out, 8 A.
-
12/48-8A (this model). 12 V to 48 V, 8 A. The 12 V input draws a lot of current for its output, so size your cable and fuse for the input side.
-
24/48-8.5A. The next step up in input voltage, for a 24 V source, with 8.5 A output.
-
12/24-15A. A 12 V source charging a 24 V bank at 15 A.
Victron also makes a non-isolated Orion-Tr Smart range. Choose isolated when you need the input and output electrically separated, as in this 12 V to 48 V case.
Is The Orion-Tr Smart 12/48-8A The Right Fit For Your System
Do the math on both sides. At 8 A and 48.2 V, the output is about 385 W, so the 12 V input needs to supply well over 30 A. Victron's manual lists a 60 A fuse and 6 to 16 mm² cable for 12 V connections, and a 20 A fuse and 2.5 to 6 mm² cable for 48 V connections, depending on cable length. Check your alternator rating, including at idle, since Victron notes alternator output can fall to roughly half of its rating at idle.
Also check polarity carefully. The Orion is not protected against reverse polarity, and Victron says a unit damaged this way cannot be repaired. Check polarity before you connect the battery.
This May Be A Good Fit If
- You have a 12 V source and a 48 V battery to charge
- You need input and output isolated from each other
- An 8 A output is enough for your charging needs
- You want Bluetooth setup and engine-running detection
- Your alternator and input wiring can supply the input current
Common Questions
Is This Charger Isolated Or Non-Isolated?
It is isolated. Victron lists galvanic isolation of 200 V DC between input, output and case for the Orion-Tr Smart isolated range.
How Much Power Does It Deliver?
Victron's specification table lists 430 W continuous output power at 25 degrees C and 360 W at 40 degrees C, with 8 A continuous output current at 40 degrees C. Output power derates 3 percent per degree C above 40 degrees C.
Can I Use It On A 48 V Lithium Battery?
Output is adjustable from 40 to 60 V and charger mode is programmable, so it can be set up for different battery types. Confirm your battery maker's charge voltage and current limits first.
Can I Connect Two In Parallel?
Victron lists the Orion-Tr Smart as parallelable, and its manual says to adjust the output voltage in the app before connecting units in parallel. Remember that each unit draws its full input current.
Does It Need A Fuse?
Yes. Victron requires a fuse on each side following its cable and fuse table, and the unit has no user-serviceable fuse inside.
What's Included
- 1 x Victron Orion-Tr Smart 12/48-8A Isolated DC-DC Charger
- 1 x Wire Loop Fitted To The Remote On/Off Terminal
Bridge Your 12 V And 48 V Systems Safely
Charging a 48 V battery from a 12 V source calls for the right conversion, isolation and protection. The Victron Orion-Tr Smart 12/48-8A brings those together with app control and engine-aware charging. At Outbound Power, we help customers plan DC-DC charging for RV, marine, vehicle and off-grid systems. Contact our team if you want help checking your input cable, fuse and alternator before you order.
Victron Orion-Tr Smart 12/48-8A Isolated DC-DC Charger Specifications
|
| Product |
| Model |
ORI124838120 |
| Name |
Orion-Tr Smart 12/48-8A Isolated DC-DC charger |
| Input |
| Input voltage range |
8 - 17 V |
| Under voltage shutdown |
7 V |
| Under voltage restart |
7.5 V |
| Output |
| Nominal output voltage |
48.2 V |
| Output voltage adjust range |
40 - 60 V |
| Output voltage tolerance |
± 0.2 V |
| Output noise |
2 mV rms |
| Continuous output current at nominal output voltage and 40 °C |
8 A |
| Maximum output current (10 s) at nominal output voltage minus 20 % |
15 A |
| Short circuit output current |
25 A |
| Continuous output power at 25 °C |
430 W |
| Continuous output power at 40 °C |
360 W |
| Maximum efficiency |
89 % |
| No load input current |
< 220 mA |
| Standby current |
Less than 1 mA |
| Galvanic isolation |
Yes, 200 V DC between input, output and case |
| Features |
| Charger mode |
3-stage adaptive (bulk, absorption, float), 8 preset battery settings, fully programmable |
| Power supply mode |
Yes, fixed output voltage |
| Engine running detection |
Yes |
| Remote on/off |
Screw terminal, two pole |
| Parallelable |
Yes |
| Communication |
Bluetooth (VictronConnect app) |
| Protections |
Short-circuit proof, overload, over temperature |
| Operating temperature range |
-20 to 55 °C (derate 3 % per °C above 40 °C) |
| Maximum humidity (non-condensing) |
95 % |
| Connections |
| DC connection |
Screw terminals, maximum cable cross-section 16 mm² (AWG 6) |
| Enclosure |
| Dimensions (h x w x d) |
130 x 186 x 80 mm (5.1 x 7.3 x 3.2 in) |
| Weight |
1.8 kg (4 lb) |
| Colour |
Blue (RAL 5012) |
| Protection category |
IP43 (electronic components), IP22 (connection area) |
| Standards |
| Safety |
EN 60950 |
| Emission |
EN 55014-1, EN-IEC 61000-6-3 |
| Immunity |
EN 55014-2, EN-IEC 61000-6-1, EN-IEC 61000-6-2 |
| Automotive directive |
ECE R10-5 |
Victron Orion-Tr Smart 12/48-8A Isolated DC-DC Charger Manual
Victron Orion-Tr Smart 12/48-8A Isolated DC-DC Charger Data Sheet