AIMS Power 7000 Watt 24 Volt 240VAC Single Phase Industrial Grade Pure Sine Power Inverter

The AIMS Power 7000 Watt 24 Volt 240VAC Pure Sine Inverter Runs 240V Pumps, Motors and Job Site Equipment From a 24V Battery Bank

The AIMS Power 7000 Watt 24 Volt 240VAC Pure Sine Inverter is an industrial grade inverter that converts 24V DC battery power into 240V AC pure sine wave power. It delivers 7000 watts continuous and 14,000 watts surge for up to 9 seconds, with one 240 volt outlet and a terminal block for direct connection.

The output is 240V AC single phase only. It does not put out two legs of 120V, so it's meant for pumps, motors, compressors and other equipment that runs on 220V, 230V or 240V AC. AIMS built it for job sites, off-grid power systems, mobile power setups and small home backup systems.

AIMS Power 7000 Watt 24 Volt 240VAC Pure Sine Inverter Features

7000 Watts of 240V Pure Sine Power

The inverter supplies 7000 watts continuous, with 29 continuous AC amps, enough to run demanding equipment or several loads at once. Full load efficiency is 90%, and no load current is 200mA.

14,000 Watt Surge for Up to 9 Seconds

Surge capacity reaches 14,000 watts, with 58 start up AC amps. The surge duration is electronically controlled: while output is between 7000 and 14,000 watts, the inverter allows up to 9 seconds and sounds a buzzer before it shuts down. That window helps equipment with high startup demands get running.

Digitally Controlled, Phase Corrected Output

AIMS describes the output as digitally outputted and phase corrected. That design helps hold voltage and frequency steady even when battery levels fluctuate or loads surge, so your equipment gets cleaner AC power.

Selectable 50 Hz or 60 Hz

A built-in frequency switch sets the output to 50 Hz or 60 Hz (±1 Hz). That lets you match equipment and regions that use either standard, and it simplifies system setup for installers.

240V Outlet Plus Direct Connect Terminal Block

A single 240 volt outlet handles a plug-in load. For high power installations, the direct connect terminal block supports secure full load wiring where a direct AC connection is required.

Protection and Status Monitoring

A low battery alarm sounds at 20V (±0.5V), and the inverter shuts down at 19.5V (±0.5V). High input voltage protection works at 34V (±0.5V), and internal fuse protection is built in. LED indicators show power, overload and over temperature status, and a load usage LED bar shows how much power you're drawing.

Aluminum Case for Tough Conditions

A heavy duty aluminum case supports cooling and protects internal parts in high vibration environments and wide temperature ranges. The cooling fan starts automatically at 107°F, and AIMS lists a full load maximum operating temperature of 163°F.

Real-World Applications

Pumps and motors. Run pumps, motors and compressors that require 240V AC from a 24V battery bank.

Job sites. Power 240V tools and equipment where there's no utility connection.

Off-grid systems. Supply 240V single phase loads in an off-grid power system built around 24V batteries.

Mobile power and home backup. Add 240V AC to a mobile power setup or a small home backup system.

Practical Comparison

Single Phase 240V Versus Two 120V Legs

Some systems supply two 120V legs that together provide 240V. This inverter doesn't. It puts out 240V AC on a single phase only, so it suits 220V, 230V and 240V equipment, not 120V loads.

Pure Sine Inverter Versus a Modified Sine Inverter

A modified sine inverter produces a stepped approximation of AC power. This inverter's digitally controlled, phase corrected pure sine output is designed to keep voltage and frequency consistent for pumps, compressors and power tools.

Inverter Only Versus an Inverter Charger

An inverter charger can also charge batteries from AC power and switch loads to it. AIMS lists no built-in charger, no AC input and no transfer switch on this model, so plan a separate way to charge your 24V bank.

Buyer Guidance

Check Your Equipment Voltage and Phase

Confirm your equipment is rated for 220V, 230V or 240V AC single phase. Equipment that needs 120V, or 120V and 240V from two legs, won't run on this inverter. Set the frequency switch to 50 Hz or 60 Hz to match your equipment.

Battery Bank and Startup Loads

The inverter runs on a 24V battery bank with a 20 to 30 volt operating range. Compare your equipment's startup demand with the 58 amp start up rating and the 9 second surge limit, since the inverter shuts down if a surge lasts longer.

This May Be A Good Fit If

• You run 240V single phase pumps or motors
• You have a 24V battery bank
• You need up to 7000 watts continuous
• You want to hardwire through a terminal block
• You don't need any 120V output

Common Questions

Does It Put Out 120V?

No. It's 240V AC single phase only and does not put out two legs of 120V.

What Output Voltage Does AIMS List?

AIMS sells it as a 240VAC inverter for 220V, 230V and 240V equipment, and its specifications list output voltage as 247V AC ±10%.

Does It Charge Batteries or Transfer to Grid Power?

No. AIMS lists no built-in charger, no AC input and no transfer switch. It's an inverter only.

Why Do the Photos Show a Modified Sine Label?

AIMS uses photos of its PWRIG700024024 industrial inverter for this model, and the labels in those photos read modified sine. The PWRIG700024024S on this page is the version AIMS sells as a pure sine inverter. If you'd like the pure sine unit's label confirmed before you order, our team can check with AIMS for you.

What Warranty Does It Have?

AIMS lists a 2-year warranty for this inverter.

What's Included

• 1 x AIMS Power 7000 Watt 24 Volt 240VAC Single Phase Industrial Grade Pure Sine Power Inverter

Heavy Duty 240V Power From 24V Batteries

The AIMS Power 7000 Watt 24 Volt 240VAC Pure Sine Inverter pairs 7000 watts of single phase pure sine output with a 14,000 watt surge, selectable 50 or 60 Hz and a direct connect terminal block. If you'd like help checking your equipment's voltage, phase and startup demand, the Outbound Power team is happy to help.