Epoch Batteries Charger Adapter With M10 Eyelets | 3/8" Ring Terminals

The Epoch Batteries Charger Adapter With M10 Eyelets Turns Your Battery Terminals Into a Plug-In Charging Point

This Epoch charger adapter is a hardwired charging lead. One end has M10 eyelets (3/8" ring terminals) that bolt to your battery posts, and the other end has a round two-pin quick-disconnect plug for a compatible Epoch charger.

Once it's installed, the battery side stays connected and you plug the charger in only when it's time to charge. It's made for boats, RVs, golf carts, battery boxes and off-grid systems where reaching the terminals is awkward.

Epoch Batteries Charger Adapter With M10 Eyelets Features

M10 Eyelets That Bolt On

The battery-side ring terminals fit M10-style or compatible 3/8-inch threaded posts, for a secure, low-profile connection you can leave in place.

Quick-Disconnect Charger Plug

The charger end is a round two-pin quick-disconnect plug. Use it with Epoch chargers that have the matching connector.

Color-Coded Leads

A red positive lead and a black negative lead make it easier to connect to the correct battery terminals.

Steadier Than Alligator Clips

Bolted ring terminals reduce the risk of a clamp slipping off, losing contact or sparking if bumped, which suits vibration-prone compartments.

Real-World Applications

Boats. Trolling motor compartments, bilges and protected battery boxes.

RVs, campers and vans. Battery bays where the terminals are hard to reach.

Golf carts. Lithium battery systems where a plug-in lead is easier than clamps.

Battery boxes and cabinets. A charging point outside the enclosure, so you don't have to open it every time.

Practical Comparison

M10 Eyelet Charger Adapter Versus Alligator Clips

Clips are handy for quick bench testing, but vibration, movement and bumps can loosen them and interrupt charging. Bolted ring terminals give a more secure, vibration-resistant connection and less terminal wear from repeated clamping.

Buyer Guidance

Check the Connector, Posts and Voltage

Make sure your charger has the matching round two-pin connector and your battery has M10-style or compatible 3/8-inch threaded posts. It works on 12V, 24V, 36V and 48V LiFePO4 systems when the charger, terminals and connector match. Wire gauge, cable length and maximum current aren't specified, so use it only with compatible Epoch charger outputs.

Install It Safely

Disconnect charging equipment first, confirm polarity and seat the ring terminals flat. Tighten to the battery maker's recommendation, route the cable away from sharp edges and moving parts, and secure the plug where it can't be pulled or submerged.

This May Be A Good Fit If

• Your Epoch charger has the round two-pin connector
• Your battery has M10 or compatible 3/8-inch posts
• You'd rather not clamp onto the terminals every charge

Common Questions

Can I Leave It Connected to My Battery?

Yes. It's designed to stay bolted to the battery terminals as a dedicated charging pigtail.

Which Epoch Chargers Does It Work With?

Epoch chargers with the matching round two-pin quick-disconnect lead. Connector styles can vary by charger model and production run, so check your charger's plug before ordering, or ask the Outbound Power team.

What Is the Wire Gauge and Amp Rating?

They aren't specified. Use the adapter only with compatible Epoch charger outputs, and inspect the cable and connector during first use.

What's Included

• 1 x Charger Adapter With M10 Eyelets

Plug-In Charging Without the Clamps

The Epoch Batteries Charger Adapter With M10 Eyelets gives your battery a bolted, plug-in charging point for boats, RVs and golf carts. If you'd like help matching it to your charger, the Outbound Power team is happy to help.