The RUiXU RX-LFP48120 Server Rack Battery Puts 6.14kWh of Self-Heating LiFePO4 Storage Into a Standard 3U Rack Space
The RUiXU RX-LFP48120 is a 51.2V, 120Ah lithium iron phosphate battery that stores 6.14kWh in a 19-inch, 3U rack module. It is the higher-capacity sibling of the RUiXU RX-LFP48100, with 6.14kWh per module instead of 5.12kWh, so a rack or cabinet holds more energy with the same number of batteries.
It is built for homeowners, installers and small businesses who pair a 48V battery bank with a hybrid or off-grid inverter for backup power, solar storage or off-grid living. Every unit has a 180W self-heater, Bluetooth app setup and RS485 and CAN inverter communication.
RUiXU RX-LFP48120 Server Rack Battery Features
6.14kWh in a 3U Rack Module
Each battery stands 5.24 inches (3U) tall and fits a standard 19-inch rack, with mounting ears that bring the front panel to 19.00 inches wide. At 6.14kWh per module, six batteries make 36.84kWh and ten make 61.40kWh, the capacities RUiXU lists for its 6-slot and 10-slot battery cabinets.
Built-In 180W Self-Heating
Lithium batteries should not charge when the cells are too cold. RUiXU's data sheet lists the 180W heater starting at or below 41°F (5°C) and stopping at or above 53.6°F (12°C), which helps in an unheated garage or utility room. The battery is still rated for indoor use only.
Bluetooth App Setup and Firmware Updates
The RUiXU Battery app connects over Bluetooth to show the status of each battery and the whole bank, set the inverter communication protocol and install over-the-air BMS firmware updates. When you connect several batteries together, they assign their own addresses automatically.
Closed-Loop Communication With Many Inverter Brands
The master battery talks to the inverter over CAN or RS485, so the inverter can follow the battery's charge and discharge limits and state of charge. RUiXU lists CAN support for Victron, SMA, Studer Innotec, Sofar, Sol-Ark, Solis, GoodWe, Deye, Growatt, SAJ, LuxPower, Megarevo, INVT, Sermatec, TBB, MUST, Sunsynk and Schneider, and RS485 support for MPP, Voltronic and RCT.
Battery Management With Pre-Charge Protection
The built-in BMS guards against overcharge, over-discharge, overcurrent, short circuits and high or low temperature, and it balances the cells. A pre-charge circuit limits inrush current when the battery connects to an inverter or charger, and the front panel has a breaker, power switch and SOC lights.
Emergency Power Off Input
A dry-contact input on the front panel accepts an emergency stop switch for rapid shutdown. When the switch is pressed, the BMS trips the breakers on the master and every connected battery.
6,000-Cycle Rating and 10-Year Warranty
RUiXU rates the RX-LFP48120 for 6,000 or more cycles at 90% depth of discharge and lists a 15-year design life. The battery carries a 10-year warranty from RUiXU.
Real-World Applications
Home Backup. Paired with a compatible hybrid inverter, a bank of RX-LFP48120 batteries keeps lights, a refrigerator, internet and other critical loads running during a grid outage.
Solar Self-Consumption. Store daytime solar production for the evening, or charge when utility rates are low and use stored energy when rates are high.
Off-Grid Homes and Cabins. With an off-grid inverter and solar array, the battery bank becomes the main energy store for a home, cabin or workshop that has no utility service.
Small Business Backup. RUiXU designed the battery for small shops, offices and light industrial sites too, where it can cover critical loads during outages and trim demand peaks.
Practical Comparison
RX-LFP48120 Versus RX-LFP48100
Both are 51.2V lithium iron phosphate server rack batteries in a 3U format. The RX-LFP48120 holds 6.14kWh per module, about 20% more than the RX-LFP48100's 5.12kWh, and self-heating is standard on every unit. It is 20.08 inches deep, so check your rack depth first.
Server Rack Battery Versus a Lead-Acid Battery Bank
A lead-acid bank needs watering or venting, loses capacity when it is discharged deeply and wears out after far fewer cycles. A LiFePO4 rack battery needs no watering, communicates with the inverter and keeps a steady voltage through most of its charge.
Modular Rack Batteries Versus One Large Battery
Rack modules let you start with the capacity you need today and add batteries later. A single large wall-mounted unit can be simpler to install, while rack batteries split the weight into 105.82 lb modules.
Buyer Guidance
Sizing Your Battery Bank
Add up the kilowatt-hours your loads use over the outage or overnight period you want to cover, then divide by 6.14kWh to estimate the number of batteries. Also check your inverter's battery current. RUiXU's manual allows one daisy-chain power connection up to 120A and two from 120A to 240A; above 240A, use a busbar or battery cabinet.
Installation and Mounting
The RX-LFP48120 mounts in a 19-inch rack, RUiXU's bracket rack, or RUiXU's 6-slot and 10-slot battery cabinets, with two screws on each side. It is rated IP20 for indoor use. A qualified installer should handle the wiring and commissioning, RUiXU recommends a DC breaker between the battery bank and the inverter, and any connection to your home's electrical panel should be done by a licensed electrician under local codes and permits.
This May Be A Good Fit If
- You are building or expanding a 48V battery bank for a hybrid or off-grid inverter
- You want more energy per rack slot than a 5.12kWh module
- Your batteries will sit in a garage or utility room that gets cold in winter
- You prefer to set up and update batteries from a phone app
Common Questions
Which Inverters Work With the RX-LFP48120?
RUiXU lists CAN or RS485 support for more than 20 inverter brands, including Victron, SMA, Sol-Ark, Deye, Growatt and Schneider. Confirm your exact model, set its protocol in the RUiXU Battery app and use the matching communication cable.
How Many Batteries Can I Connect Together?
The batteries connect in parallel and assign their own addresses. RUiXU's 6-slot cabinet holds up to 36.84kWh and its 10-slot cabinet holds up to 61.40kWh of RX-LFP48120 batteries, and larger banks are possible.
What Warranty Does the RX-LFP48120 Have?
RUiXU backs the RX-LFP48120 with a 10-year warranty.
Which Cables Come With the Battery?
Each battery includes a communication cable and a grounding cable for linking to the next battery, plus short red and black 4 AWG cables for a busbar. The power cables to the inverter or busbar, the main grounding cable and the inverter communication cable are sold separately and should be sized for your system.
What's Included
- 1 x RUiXU RX-LFP48120 Server Rack Battery
- 1 x Operation Manual
- 1 x Warranty Card
- 1 x Battery-to-Battery Communication Cable (250 mm)
- 1 x Battery-to-Battery Grounding Cable (430 mm)
- 1 x Red Positive Battery-to-Busbar Cable (4 AWG, 150 mm)
- 1 x Black Negative Battery-to-Busbar Cable (4 AWG, 150 mm)
Multi-Battery Options
- 2, 3, 4, 5, 6 or 12 x RUiXU RX-LFP48120 Server Rack Battery, Each With the Items Above
More Stored Energy in Every Rack Slot
The RUiXU RX-LFP48120 Server Rack Battery gives you 6.14kWh of LiFePO4 storage in a 3U module, with self-heating, Bluetooth setup and closed-loop inverter communication on every unit. If you need help sizing a battery bank, choosing cables and busbars or matching the battery to your inverter, the Outbound Power team is ready to help.
RUiXU RX-LFP48120 51.2V 120Ah Server Rack Battery Specifications
|
| Battery |
| Model |
RX-LFP48120 |
| Nominal Voltage |
51.2V |
| Nominal Capacity |
120Ah |
| Nominal Energy |
6.14kWh (6,144Wh) |
| Cell Type |
Lithium iron phosphate (LiFePO4) |
| Cycle Life |
6,000+ cycles at 90% DOD |
| Design Life |
15 years |
| Electrical |
| Operating Voltage Range |
43.2V to 58.4V |
| Charge Voltage |
56.8V |
| Max Charging Voltage |
58.4V |
| Charge Current |
70A recommended, 110A max |
| Discharge Current |
70A recommended, 110A max |
| Peak Discharge Current |
120A for 15 s, 150A for 1 s |
| Max Discharge Power |
5kW |
| Communication and Control |
| Communication Ports |
RS485, CAN |
| Wireless |
Bluetooth (RUiXU Battery app) |
| App Functions |
Monitoring, inverter protocol setup, OTA firmware updates |
| Emergency Power Off |
Dry-contact input (rapid shutdown) |
| Self-Heating |
| Heater Power |
180W |
| Heating Starts |
At or below 41°F (5°C) |
| Heating Stops |
At or above 53.6°F (12°C) |
| Environment |
| Operating Temperature |
14°F to 113°F (-10°C to 45°C) |
| Storage Temperature |
-4°F to 122°F (-20°C to 50°C) |
| Relative Humidity |
5% to 90%, non-condensing |
| Max Install Altitude |
4,000 m (13,123 ft) |
| IP Rating |
IP20 |
| Install Location |
Indoor |
| Size and Weight |
| Rack Format |
19-inch, 3U |
| Dimensions (W x H x D) |
19.00 x 5.24 x 20.08 in (482.6 x 133.5 x 510 mm) |
| Body Width Without Mounting Ears |
17.36 in (441 mm) |
| Net Weight |
105.82 lb (48 kg) |
| Certifications and Warranty |
| Certifications |
UL 1973, UL 9540A, CEC, UN 38.3, IEC 62619, IEC 61000, CE |
| Warranty |
10 years |
RUiXU RX-LFP48120 Manual
RUiXU RX-LFP48120 Data Sheet