The Epoch Batteries 12V 460Ah MC (5.89kWh) LiFePO4 Battery Puts Victron CAN, Bluetooth And A Remote Switch In One IP65 Case
The Epoch Batteries 12V 460Ah MC (5.89kWh) LiFePO4 Battery, model C12460C, is a V2 Elite Series battery rated at 12.8V nominal and 460Ah, for 5,888Wh of stored energy. Inside is a 4S2P pack of 230Ah lithium iron phosphate cells managed by one BMS, so one battery can do the job of a bank of smaller ones with fewer cables and connection points.
It's built for large 12V house-power and energy-storage systems on boats, RVs, vans, off-grid cabins and backup systems. It talks to Victron GX devices over CAN, includes a Bluetooth State of Charge meter and a remote power switch, and has no internal heater. It is a deep-cycle battery, not cranking-rated, so it is not for starting an engine.
Epoch Batteries 12V 460Ah MC (5.89kWh) LiFePO4 Battery Features
Native Victron CAN Communication With DVCC
The battery connects to a Cerbo GX, Ekrano GX or Cerbo GX MK2 over CAN bus at 500 kbit/s through its VICTRON and CAN RJ45 ports, using the included communication harness. With DVCC on and Epoch set as the controlling BMS and battery monitor, the BMS publishes its charge limits and state of charge, so your Victron chargers follow the battery.
230A Continuous Charge And Discharge For Large Inverters
Epoch rates it for 230A continuous discharge and 230A continuous charge (0.5C, also the recommended rate), about 2,944W DC at 12.8V before inverter losses. For inverter surge it supplies 500A for up to 10 seconds, and it accepts up to 400A of charge for 5 seconds. Size your loads, cables and fusing to the 230A continuous rating.
A Remote Power Switch And One Terminal Panel
A 16 mm illuminated push button on a 9.8 m (32.2 ft) cable plugs into the EXTERNAL SWITCH connector, so you can turn the battery on and off from a dash, helm or electrical panel. The covered bolt terminals, RJ45 ports, DIP switches, vent and switch connector all sit on one terminal panel.
IP65 Enclosure For Spray And Dust
The case is dust-tight and protected against water jets from any direction, with the terminal covers closed and all connectors and seals in place. It is not rated for immersion, so mount it where it can't stand in water.
Bluetooth State Of Charge Meter
The included meter shows state of charge, voltage and current, and houses the Bluetooth 4.0 module for the free Epoch Cloud app on iOS and Android.
Smart BMS Protection
The BMS protects against over-voltage, under-voltage, over-current, over-temperature and short circuit. It protects the cells, not your wiring, so you still need a fuse or DC-rated breaker as close as practical to the battery positive.
3,500+ Cycles And An 11-Year Limited Warranty
Epoch rates it for more than 3,500 cycles to 70% capacity (25°C, 0.5C charge, 1C discharge, 70% depth of discharge), with no watering or equalizing. It's backed by an 11-year limited warranty with free repair or replacement for the first 5 years, then 40% off MSRP. Register it within 90 days of purchase for full coverage.
Real-World Applications
-
Marine house banks. Power the house loads on yachts, workboats and large cruising boats, with the battery mounted where it stays out of standing water.
-
RV and van house power. Pair it with a large 12V inverter and solar charging in a motorhome, conversion van, travel trailer or fifth wheel.
-
Victron systems. Let a Cerbo GX or Ekrano GX manage charging through DVCC, with the battery's own limits in control.
-
Off-grid cabins and backup storage. Grow from one 5.89kWh battery to as many as 16 in parallel (7,360Ah, 94.2kWh).
How It Compares To The Epoch 12V 460Ah V2 Elite (C12460A)
Same capacity, different build. Both store 5.89kWh at 12V and talk to Victron over CAN. The C12460A adds self-heating and an IP67 immersion-rated case, with its mounting bracket sold separately. The C12460C has no heater and uses a taller, narrower IP65 case with mounting brackets included.
Choose the C12460C if your battery stays above freezing when it charges, or the compartment is heated. Choose the C12460A if you need to charge below freezing or want an immersion-rated case.
Versus lead-acid or AGM. It is not a drop-in replacement for every installation. Check tray fit, terminal clearance, cable size, fusing and your charger profile first.
Is The Epoch 12V 460Ah MC The Right Fit
Series or parallel, not both. Up to 4 in series (51.2V nominal) or up to 16 in parallel, using matched C12460C batteries of similar age, condition and firmware at the same state of charge. Set one battery as the Master with the DIP switches. Series-parallel banks are not supported.
Charger settings. LiFePO4 CC/CV profile, 14.2V absorption for 15 minutes per battery in the bank, 13.5V float, termination at 0.02C (9.2A), equalization and temperature compensation disabled, and never above 14.6V. Program every charge source, Victron included, as a fallback in case communication is lost.
Cold charging. Charge only between 0°C and 55°C (32°F and 131°F). Discharge is allowed from -20°C to 55°C (-4°F to 131°F).
Fit and weight. 23.2 x 7.5 x 15.2 in (589 x 190 x 385 mm) over the brackets and terminal covers, and about 105.8 lb (48 kg). Install it upright and bolt it down through the end brackets.
This May Be A Good Fit If
- You're building a large 12V house bank around one battery
- You use a Victron Cerbo GX, Ekrano GX or Cerbo GX MK2
- You want to switch the battery on and off from a dash or helm
- Your battery stays above freezing when it charges
Common Questions
Do I Need A Special Cable For My Cerbo GX?
Not for a single battery. Plug the included harness into the VICTRON port and its RJ45 plug into the BMS-CAN port of a Cerbo GX or Ekrano GX. On a Cerbo GX MK2, use VE.CAN 1 or VE.CAN 2 at 500 kbit/s. For a bank, run RJ45 cables from each battery's CAN port to the next battery's VICTRON port.
Can I Charge It Below Freezing?
No. This model has no internal heater, and the BMS stops charging outside 0°C to 55°C. If the battery is below freezing, let it warm up first, for example by heating the compartment, and charging resumes once it's back in range.
How Should I Store It?
Store it at 0°C to 35°C (32°F to 95°F) for up to a year. Short-term storage from -20°C to 45°C is fine for up to a month. It ships at about 30% charge, so charge it fully before first use.
What's Included
- 1 x Epoch 12V 460Ah MC V2 Elite LiFePO4 Battery (C12460C)
- 1 x State Of Charge Meter With Bluetooth
- 1 x Communication Harness
- 1 x Remote Power Switch With 32.2 ft Cable
- 2 x Mounting Brackets (One At Each End)
A Large 12V Bank In One Victron-Ready Case
The Epoch Batteries 12V 460Ah MC (5.89kWh) LiFePO4 Battery gives a 12V system 5.89kWh in one IP65 case, with Victron CAN communication, Bluetooth monitoring and a remote power switch. If you have questions about charger settings, Victron setup or bank sizing, the Outbound Power team is happy to help.
Epoch C12460C Specifications
|
| Model |
C12460C |
| Series |
V2 Elite Series |
| Battery type |
Deep-cycle (not cranking-rated) |
| Chemistry |
LiFePO4 (lithium iron phosphate) |
| Cell configuration |
4S2P (230Ah cells) |
| Internal heating |
None |
| Voltage and Capacity |
| Nominal voltage |
12.8V (3.2V per cell) |
| Nominal capacity |
460Ah (0.5C, 25°C) |
| Stored energy |
5,888Wh (5.89kWh) |
| Operating voltage range |
10V – 14.6V |
| Maximum charge voltage |
14.6V (3.65V per cell) |
| Minimum voltage |
10V (2.5V per cell) |
| Usable state of charge |
0–100% |
| Self-discharge |
≤3% per month (100% SOC, 25°C) |
| Insulation resistance |
≥20 MΩ at 1,000V DC |
| Shipped state of charge |
30% ± 3% |
| Cycle life |
3,500+ cycles to 70% capacity |
| Cycle life conditions |
25°C, 0.5C charge, 1C discharge, 70% DoD |
| Current Ratings (25°C, 50% SOC) |
| Continuous discharge |
230A (0.5C) |
| Peak discharge |
500A for up to 10 s |
| Continuous charge |
230A (0.5C) |
| Peak charge |
400A for up to 5 s |
| Continuous power at 12.8V |
About 2,944W DC (before inverter losses) |
| Series and Parallel |
| Series |
Up to 4 batteries (51.2V nominal) |
| Parallel |
Up to 16 batteries (7,360Ah / 94.2kWh) |
| Series-parallel |
Not supported |
| Bank communication |
Daisy-chained CAN, no branches or tees |
| Bank roles |
One Master, others Members (DIP switches) |
| Recommended Charging Settings |
| Charge profile |
LiFePO4, CC/CV |
| Recommended charge current |
230A (0.5C) per battery |
| Bulk / absorption voltage |
14.2V |
| Absorption time |
15 minutes per battery in the bank |
| Charge termination |
Current ≤0.02C (9.2A) |
| Float voltage |
13.5V |
| Equalization |
Disabled |
| Temperature compensation |
Disabled (0 mV/°C) |
| Never exceed |
14.6V (3.65V per cell) |
| Alternator charging |
DC-to-DC charger for LiFePO4 |
| Victron Communication |
| Protocol |
CAN bus at 500 kbit/s |
| Battery ports |
VICTRON and CAN (RJ45) |
| GX devices |
Cerbo GX, Ekrano GX, Cerbo GX MK2 |
| Cerbo GX / Ekrano GX port |
BMS-CAN |
| Cerbo GX MK2 port |
VE.CAN 1 or 2 at 500 kbit/s |
| GX settings |
DVCC on; BMS and monitor set to Epoch |
| Monitoring and Controls |
| State of Charge meter |
Included; shows SOC, voltage, current |
| Bluetooth |
Bluetooth 4.0 in the State of Charge meter |
| App |
Epoch Cloud (iOS and Android) |
| Remote power switch |
16 mm illuminated push button |
| Remote switch cable |
9.8 m (32.2 ft) |
| External switch connector |
4-pin circular |
| Temperature |
| Charge |
0°C to 55°C (32°F to 131°F) |
| Discharge |
-20°C to 55°C (-4°F to 131°F) |
| Short-term storage |
-20°C to 45°C, up to 1 month |
| Recommended storage |
0°C to 35°C, up to 1 year |
| Cooling |
Passive (natural convection) |
| BMS Protection |
| Over-voltage |
14.6V (3.65V per cell) |
| Under-voltage |
Alarm, then shutdown at 10V |
| Over-current |
Shutdown above the current ratings |
| Over-temperature |
Shutdown outside the temperature ranges |
| Short circuit |
Shutdown on an external short |
| Dimensions and Weight |
| Overall length |
23.2 in (589 mm) with brackets |
| Length without brackets |
21.5 in (545.3 mm) |
| Width |
7.5 in (190 mm) |
| Overall height |
15.2 in (385 mm) with terminal covers |
| Height without terminal covers |
13.6 in (345 mm) |
| Weight |
105.8 ± 8.8 lb (48 ± 4 kg) |
| Mechanical |
| Enclosure |
IP65 (IEC 60529), not for immersion |
| Terminals |
Covered bolt terminals |
| Terminal covers |
Orange positive, black negative |
| Terminal torque |
12 N·m (8.85 lb·ft) maximum |
| Mounting |
Brackets at both ends (included) |
| Orientation |
Upright |
| Compliance and Warranty |
| Cell certification |
GB/T |
| Enclosure rating |
IP65 per IEC 60529 |
| Warranty |
11-year limited |
| Warranty terms |
5 years free repair or replacement, then 40% off MSRP |
| Registration |
Within 90 days of purchase |