EARLY BLACK FRIDAY SALE IS LIVE  |  SHOP NOW WITH OUR PRICE DROP GUARANTEE →
EARLY BLACK FRIDAY SALE IS LIVE  |  SHOP NOW →
Skip to content

SunGold Power 2000W DC 12V Pure Sine Wave Inverter With Charger

|
SKU: LFP2K12V120VSG
$730.59

Early Black Friday Price Drop Guarantee

  • Buy now, and if our price drops by Black Friday, we'll refund the difference.
  • Found it lower elsewhere? We'll beat it.

We Beat Any Price

Found the same price or less? Just ask & we'll beat it.


The SunGold Power 2000W DC 12V Pure Sine Wave Inverter With Charger Turns a 12V Battery Bank Into 2000 Watts of Clean 120V Power

The SunGold Power 2000W DC 12V Pure Sine Wave Inverter With Charger is a low-frequency LFP Series unit that puts three jobs in one case: a 2000W pure sine wave inverter, a 70A battery charger and an automatic AC transfer switch. It runs from a 12V battery bank, accepts 120VAC from the grid or a generator, and supplies 120VAC to your loads.

It is built for RVs, trailers, motorhomes, truck campers, cabins and home backup circuits where a 12V bank is already in place. A 6000W surge rating, a GFCI outlet, an LCD display and an included remote control make it a practical center for a small backup or off-grid system.


SunGold Power 2000W DC 12V Pure Sine Wave Inverter With Charger Features

2000W Continuous With a 300% Surge

The inverter delivers 2000W continuously and 6000W for up to 20 seconds, three times its rating. SunGold rates it to start a 2HP electric motor. That reserve helps with pumps, compressors and power tools that pull a burst of current at start-up.

Built-In 70A Multi-Stage Charger

When grid or generator power is connected, the power factor corrected charger refills the bank at up to 70A ±5A. A linear switch sets the maximum anywhere from 0% to 100%, which helps when the bank is small. Nine battery type settings cover gel, AGM, sealed lead acid, lithium and LiFePO4 profiles, and position 0 turns the charger off.

Automatic Transfer With a Generator Delay

If AC input fails or drifts out of range, the transfer switch moves your loads to battery power, with a typical transfer time of 10ms or less. When qualified AC returns, a 15-second delay gives a generator time to settle before the loads move back. That keeps relays from chattering on unstable power.

AC or Battery Priority

By default the inverter favors AC. Incoming power charges the battery and passes through to the loads. Set SW5 to battery priority and the inverter runs loads from the bank until it reaches the low battery alarm point, then switches to AC, recharges and returns to battery once the bank is full. SunGold designed this mode for solar or wind systems that keep utility power as backup.

Automatic Generator Start

The inverter can signal a generator to start when battery voltage runs low, then shut it off once charging is finished. The generator needs its own auto start function, and the start relay carries up to 16A.

Power Saver Mode

Idle consumption is 28W with power saver off and 13W with it on. In power saver mode the inverter pulses its output to look for a load and wakes up when something above 25W turns on. That saves battery when the system sits unused.

Protections and a Coated Circuit Board

Built-in protections cover AC input over and under voltage, low and high battery voltage, over temperature, overload, short circuit and backfeed. The PCB has a conformal coating that makes it water, rust and dust resistant, though the unit is not splash proof.


Real-World Applications

RVs and motorhomes. Run a microwave, blender or coffee maker from the house battery, then recharge from shore power or a generator through the same unit.

Trailers and truck campers. Add 120V outlets to a 12V system without buying a separate charger and transfer switch.

Home backup circuits. Keep lights, electronics or a home office running during an outage, with the inverter taking over automatically when the grid drops.

Workshops and job sites. Power drills, saws, grinders and other tools that fit within 2000W, with surge headroom for start-up.


How It Compares to Common Alternatives

Versus the 3000W 12V model. The 3000W version adds 1000W of output, a 9000W surge, a 3HP motor rating and a 90A charger. It weighs 49 lb against 41.9 lb for this model, in the same 22 x 9.1 x 7.5 inch footprint.

Versus a modified sine wave inverter. Pure sine wave output gives clean power for sensitive electronics and for appliances such as microwaves that can run poorly on a stepped waveform.

Versus separate components. One unit replaces an inverter, a battery charger and a transfer switch, with one display, one remote and one set of DC cables to the bank.


Is This 12V Inverter Charger the Right Fit

  • Battery bank. Requires a 12V bank. The inverter starts at 10.0Vdc and restarts on its own once the battery recovers to 13Vdc after a low voltage shutdown.
  • AC source. Accepts 120VAC grid or generator power, with an input range of 90 to 135VAC or 100 to 135VAC set by SW2.
  • Cabling. SunGold lists AWG1/0 as the minimum DC cable for a 3 meter run on this model. Keep the bank close to the inverter.
  • Location. Install it somewhere dry, clean, cool and ventilated, with at least 30cm (11.81 inches) of clearance for airflow.
  • Size. 22 x 9.1 x 7.5 inches and 41.9 lb, for wall mounting.

This may be a good fit if

  • You already run a 12V battery bank
  • Your loads stay within 2000W continuous
  • You want charging and transfer in one unit
  • You want a GFCI outlet on the inverter

Common Questions

What Is the Standby Current Draw?

SunGold lists the standby current at 2A for this 12V model. Idle consumption is 28W with power saver off and 13W with power saver on.

What Wire Size Should Be Used for the Chassis Ground?

SunGold's answer for this model is AWG1/0 wire. The manual's general minimum is AWG 8 copper between the ground terminal and the earth ground or vehicle chassis, so AWG1/0 meets it.

What Happens in Battery Priority When the Battery Runs Down?

The inverter switches to AC and charges the battery. Once the battery is recharged, it switches back to inverting from the battery.

What Can a 2000W Inverter Run?

Household appliances such as blenders, microwaves and coffee makers, plus power tools and electronics. Keep the total running load within 2000W and allow for the start-up surge of motor loads.

Does It Work With Lithium Batteries?

Yes. It can charge LiFePO4 and other lithium batteries. Check your battery's charge and cutoff voltages against the inverter's battery type settings before you choose one.


What's Included

  • 1 x 2000W 12V Low Frequency Pure Sine Inverter (LFP2K12V120VSG)
  • 1 x English Manual
  • 1 x Remote Control
  • 1 x BTS Cable

Clean 120V Power and Charging in One 12V Unit

The SunGold Power 2000W DC 12V Pure Sine Wave Inverter With Charger gives a 12V system 2000W of pure sine wave output, a 70A charger and automatic transfer in one wall-mounted unit. At Outbound Power, we help customers match inverters, battery banks and generators for RVs, cabins and home backup. If you have questions, our team is happy to help.


SunGold Power 2000W DC 12V Pure Sine Wave Inverter With Charger Specifications

Model LFP2K12V120VSG
Inverter Output
Continuous Output Power 2000W
Surge Rating 6000W (20 seconds)
Capable of Starting Electric Motor 2HP
AC Output Voltage 120VAC
Output Frequency 50Hz or 60Hz (set by SW4)
Output Waveform Pure sine wave (bypass mode)
Typical Transfer Time 10ms (max)
Nominal Efficiency >88%
Line Mode Efficiency >95%
Outlet GFCI socket
DC Input
Nominal Input Voltage 12.0Vdc
Minimum Start Voltage 10.0Vdc
Low Battery Alarm 10.5Vdc to 11.0Vdc
Low Battery Trip 10.0Vdc to 10.5Vdc (select by SW1)
High Voltage Alarm 16.0Vdc
Low Battery Voltage Restart 13Vdc
Idle Consumption 28W
Power Saver Mode Idle Consumption 13W
AC Charger
AC Input Voltage 120VAC
AC Input Range (Grid or Generator) 90V to 135VAC / 100V to 135VAC (select by SW2)
Charger Rate 70A ±5A
Adjustable Charge Current Off, 0% to 100%
Battery Type Settings 9
Charging 3-step intelligent battery charger
Over Charge Protection Shutdown 15.7V
Charger Breaker Rating 20A
Bypass Breaker Rating 30A
General
Display LCD
Remote Control Included
Battery Temperature Sensor BTS cable included
Mounting Wall mount
Working Temperature -10°C to 40°C
Unit Weight 41.9 lb
Unit Size 22 x 9.1 x 7.5 in
Shipping Weight 50.3 lb
Shipping Size 26.8 x 13.4 x 13 in
Standard Warranty 1 Year

SunGold Power LFP2K12V120VSG Manual

SunGold Power LFP2K12V120VSG Manual

SunGold Power LFP2K12V120VSG Data Sheet

SunGold Power LFP2K12V120VSG Data Sheet

Common Customer Questions

Get answers to the most frequently-asked questions customers ask before placing an order.

Is Outbound Power an Authorized Dealer?

Yes! Outbound Power is an Authorized Dealer for every single brand and product on our store.

How long will it take for my order to arrive?

Shipping times vary depending on your location and the product or products ordered.

Order Processing Time
Most products are processed within 1-3 business days. If there is a delay in processing your order, we will alert you with as much information as possible about what to expect.

After order processing is complete, you will receive tracking information to monitor your order while it is in transit.

Order Shipping Time
Following processing, it may take between 3 and 8 days to arrive, depending on your location.

Please refer to the product page for your item and reference the estimated delivery time frame for more details.

Additionally, you can see the estimated delivery time frame during checkout and receive a tracking number once your order ships.

What are your shipping rates? Do you offer free shipping?

Everything on our store ships for free. Really!

What is Outbound Power's return policy?

Most items may be returned within 30 days of delivery. Please refer to our Returns & Exchanges policy to determine what items are eligible. Returns are not accepted beyond 30 days following delivery.

Are Outbound Power products used/old/refurbished?

Everything sold on our website is brand-new.

Do you price match?

No — we price BEAT! Please refer to our Price Beat Promise for full details.