Wagan Tech Pure Line 2000W Pure Sine Inverter (ETL) | 12V
Early Black Friday Price Drop Guarantee
- Buy now, and if our price drops by Black Friday, we'll refund the difference.
- Found it lower elsewhere? We'll beat it.
Early Black Friday Price Drop Guarantee

The Wagan Pure Line 2000W Pure Sine Inverter turns 12 volt DC battery power into 115 volt, 60 Hz pure sine wave AC. It's rated for 2,000 watts continuous with a 4,000 watt surge, and it gives you three grounded AC outlets, a 2.1A USB port and high output terminals for hard-wired loads.
Wagan builds it for RVs, trucks, boats, campers and off-grid systems that run household-style appliances and electronics. It's ETL certified to UL 458 and CSA C22.2 No. 107.1 standards, RoHS compliant and CE approved.
The inverter produces a true AC sine wave like commercial power, with total harmonic distortion under 3%. Wagan designed it so sensitive gear such as audio and video systems, computers and communications equipment works properly, and so appliances with motors run cooler, quieter and more efficiently.
Wagan's TrueRated label means the inverter is tested at its full 2,000 watt load and holds that load continuously for 24 hours. The 4,000 watt momentary surge gives motorized appliances room to start. Startup loads are often about twice the running load and can reach eight times, so compare your appliance's startup draw with the surge rating.
Three grounded, ground fault protected NEMA 5-15 outlets supply up to 15 amps at 115V AC. A 115V device that needs more than 15 amps, or distributed wiring with several outlets, connects to three insulated high output terminals (neutral, ground and live) under a screw-down cover, wired to National Electric Code gauge recommendations. A 5V, 2.1A USB port charges phones and tablets.
Green means normal operation, yellow means the ground fault circuit has tripped, and red means the inverter has shut down for overheating, overload, low voltage or high voltage. A buzzer sounds at 10.5V as the battery runs low, and the inverter shuts off at 10.0V or above 16.5V. Twin load and temperature controlled cooling fans manage heat.
Removable safety covers over the solid mount DC terminals reduce the risk of an accidental short during installation. A separate ground terminal bonds the case to a vehicle chassis or boat grounding system and helps reduce conversion noise around radio frequency devices. Neutral and ground are bonded inside, like utility power. The enclosure vents are kept small to reduce the risk of pests getting in, and the circuit board has a conformal coating.
Set the On, Off, Remote switch to Remote and plug Wagan's optional Pure Line Inverter Remote (item 5603, sold separately) into the front-panel connection to turn the inverter on and off from another location.
RVs and campers. Run kitchen appliances such as a coffee maker or blender from the house battery bank.
Work trucks. Power corded tools such as a drill or circular saw within the 2,000 watt rating.
Boats. Ground the case to the boat's grounding system and power onboard electronics.
Off-grid systems. Feed hard-wired outlets through the high output terminals, installed to code.
A modified sine inverter does not reproduce the true sine wave of utility power. This one does, and Wagan built it for sensitive electronics such as audio and video equipment, computers and communications gear, as well as motorized appliances. If those are part of your load, a pure sine inverter is the type to choose.
Use the outlets for plug-in loads up to 15 amps. Use the high output terminals for a single 115V device that needs more current, or to supply hard-wired outlets. Either way, the total AC load stays within 2,000 watts continuous.
Wagan's rule of thumb is to divide AC watts by 10 to estimate DC amps at 12 volts, so size the battery bank and cabling for heavy current. Use deep-cycle, sealed lead acid batteries indoors or inside a vehicle or vessel, and plan extra capacity for heavy discharge. Install a 200 amp ANL fuse in the positive cable within 1 foot of the battery. The supplied 3 foot cables cover round trips up to 5 feet in a vehicle with the engine running. For longer round trips, Wagan lists 0 AWG at 6 to 8 feet, 00 AWG at 10 feet, 000 AWG at 12 to 14 feet and 0000 AWG at 16 feet. Reversed battery polarity damages the inverter and voids the warranty, so confirm red to positive and black to negative.
Choose a dry, secure location away from heat sources and combustibles, with free airflow at the front and rear. Wall mounting must be horizontal. Run insulated 10 gauge copper wire from the ground terminal to the vehicle chassis, the boat's grounding system or the battery's negative terminal, not to the inverter's own negative terminal. Operating temperature is -4°F to 104°F (-20°C to 40°C).
Wagan specifies a 200 amp ANL fuse and fuse holder in the positive battery cable, within 1 foot of the battery's positive terminal.
A continuous buzz means input voltage is below 10.5 volts. Recharge or replace the battery, tighten any loose connections, and use heavier gauge, shorter DC cables if voltage drop is the cause.
The ground fault circuit has tripped. Disconnect your appliances, then turn the switch off and back on to reset it.
Up to 100 feet for temporary use, with a safety-approved cord of 14 AWG or heavier.
Wagan warrants it to the original purchaser for two years from the purchase date against defects in material and workmanship.
The Wagan Pure Line 2000W Pure Sine Inverter brings 2,000 watts of TrueRated pure sine power, three outlets, USB charging and hard-wire terminals to your 12V system, with ground fault protection and remote control capability. If you'd like help planning the battery bank, fuse or cable runs, the Outbound Power team is happy to help.
Wagan Tech Pure Line 2000W Pure Sine Inverter (ETL) 12V Specifications |
|
|---|---|
| Model | 3808 |
| Output | |
| Continuous Power (TrueRated) | 2,000W, 24-hour continuous |
| Surge Power | 4,000W |
| Output Waveform | Pure sine wave |
| AC Output Voltage | 115V AC |
| Frequency | 60Hz |
| Total Harmonic Distortion | Less than 3% |
| Efficiency | Up to 90% |
| No Load Current Draw | Less than 2.0A |
| DC Input | |
| Input Voltage | 12V DC |
| Operating Input Range | 11V to 15V DC |
| Low Battery Alarm | 10.5V ± 0.5V DC |
| Low Battery Shutdown | 10.0V ± 0.5V DC |
| Over Voltage Shutdown | 16.5V ± 0.5V DC |
| DC Terminals | Solid mount positive and negative, removable safety covers |
| Included DC Cables | 36 in. (3 ft), 2 AWG, ring connectors |
| Outlets and Ports | |
| AC Outlets | 3 grounded NEMA 5-15, ground fault protected |
| AC Outlet Current | Up to 15A at 115V AC |
| High Output AC Terminals | 3 insulated (neutral, ground, live), for loads over 15A |
| USB Power Port | 5V, 2.1A |
| Power Switch | On, Off, Remote |
| Remote Switch Connection | Yes, wired remote item 5603 sold separately |
| Indicators | Power LED (green), ground fault LED (yellow), fault LED (red) |
| Protection | |
| Overload | Automatic shutdown |
| Overheating | Cooling fans with automatic shutdown |
| Short Circuit | Internal fuses |
| Ground Fault | Ground fault protected outlets |
| Low Battery | Audible alarm and automatic shutdown |
| Neutral to Ground Bond | Yes |
| Grounding | Separate ground terminal (true ground) |
| Cooling | Twin fans, load and temperature controlled |
| Circuit Board | Conformal coating |
| Installation | |
| Recommended Battery Fuse | 200A ANL |
| Fuse Location | Within 1 ft of battery positive terminal |
| Supplied Cables | Round trip up to 5 ft, vehicle engine running |
| Cable Gauge, 6 to 8 ft Round Trip | 0 AWG |
| Cable Gauge, 10 ft Round Trip | 00 AWG |
| Cable Gauge, 12 to 14 ft Round Trip | 000 AWG |
| Cable Gauge, 16 ft Round Trip | 0000 AWG |
| Battery Type | Deep-cycle sealed lead acid |
| Battery Current Estimate | AC load in watts divided by 10 = DC amps at 12V |
| Ground Wire | Insulated 10 gauge copper |
| Wall Mounting | Horizontal |
| Extension Cord | 100 ft max, 14 AWG or heavier |
| Physical | |
| Dimensions | 17.5 x 8.7 x 3.7 in |
| Net Weight | 11.7 lb |
| Operating Temperature | -4°F to 104°F (-20°C to 40°C) |
| Certifications and Warranty | |
| Certifications | ETL certified to UL 458 and CSA C22.2 No. 107.1, RoHS compliant, CE approved |
| Warranty | 2 years, original purchaser |
⚠ WARNING: This product can expose you to chemicals including LEAD, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Yes! Outbound Power is an Authorized Dealer for every single brand and product on our store.
Shipping times vary depending on your location and the product or products ordered.
Order Processing Time
Most products are processed within 1-3 business days. If there is a delay in processing your order, we will alert you with as much information as possible about what to expect.
After order processing is complete, you will receive tracking information to monitor your order while it is in transit.
Order Shipping Time
Following processing, it may take between 3 and 8 days to arrive, depending on your location.
Please refer to the product page for your item and reference the estimated delivery time frame for more details.
Additionally, you can see the estimated delivery time frame during checkout and receive a tracking number once your order ships.
Everything on our store ships for free. Really!
Most items may be returned within 30 days of delivery. Please refer to our Returns & Exchanges policy to determine what items are eligible. Returns are not accepted beyond 30 days following delivery.
Everything sold on our website is brand-new.
No — we price BEAT! Please refer to our Price Beat Promise for full details.
Click to apply at checkout
placeholder